1. Liability for content
The content included on our website was created with great care. We cannot, however, assume any liability for the accuracy, completeness, or currency of the content. In particular, this applies to websites that are referred to via hyperlinks. In accordance with section 7 (1) of the German Telemedia Act (Telemediengesetz – TMG), we as a service provider are responsible for proprietary content on these pages, in accordance with general legislation. Pursuant to sections 8 to 10 TMG, however, we as a service provider are not responsible for monitoring third-party information transmitted or stored, nor for investigating circumstances that might indicate unlawful activities. This is without prejudice to our obligation to remove or block the use of information in accordance with general legislation. Any liability in this respect can only be established from the time that a definite violation of the law has been identified. Should we become aware of any violations, we will remove such content immediately.
The FIT Additive Manufacturing Group reserves the right to make changes or additions to the information or data provided at any time without notice. To the extent that our web pages contain forward-looking statements, such statements are based on convictions and assessments of FIT management and are therefore subject to risks and uncertainties. The FIT Additive Manufacturing Group is under no obligation to update such forward-looking statements. Liability for such statements is expressly excluded.
2. Liability for links
Our offering contains links to external websites of third parties; we have no influence over the content of these websites. The FIT Additive Manufacturing Group expressly disclaims any liability for the content of such sites. The respective provider or operator of the websites is always responsible for the contents of the linked pages. Linked websites were inspected for any legal infringement at the time the link was established. Illegal content was not identifiable at the time the link was established. However, permanent content control of the linked pages is not reasonable without concrete evidence of a violation. Should we become aware of any violations, we will remove such links immediately.
All rights reserved.
Content, including images, and the design of the FIT Additive Manufacturing Group website are protected by copyright and other intellectual property laws. The reproduction, processing, distribution and any kind of utilization not permitted under copyright require the written consent of the respective author or creator. The distribution or modification of the content of these pages, including framing and similar measures, is not permitted. In addition, the content may not be copied, distributed, modified, or made accessible to third parties for commercial purposes. If the content on this site was not created by the operator, the copyrights of third parties will be observed. In particular, content of third parties is identified as such. However, we ask that you contact us if you notice any copyright infringement. Should we become aware of any violations, we will remove such content immediately.